no im afraind not. that is for the 2 litre sr engine

This one will fit.

http://cgi.ebay.co.uk/NISSAN-200SX-S...QQcmdZViewItem

Thanks for that, I was going to go for the Exedy anyway but spotted that cheaper, better clutch kit.

Harumph! Just went to try the pressure plate up against the flywheel and it is too large! I thought you all said the 200sx clutch would fit :(

I'm starting to think that I have been sent the wrong clutch as there is no listings of any sort on the box and it doesn't fit on the spare CA18ET engine I have at the back of my shed either.

The friction plate on the new clutch is 24cm whereas the original off the car is 22.5cm
The pressure plate is physically larger and none of the bolt holes line up.

http://i35.photobucket.com/albums/d1...1-clutch-1.jpg
http://i35.photobucket.com/albums/d1...1-clutch-2.jpg
http://i35.photobucket.com/albums/d1...1-clutch-3.jpg

that's for an SR20 :)

So it's "justclutch"es screw up then?
Looking around on ebay again, there are other who list silvia clutches and they have 2, a pre '90 clutch and one for '90-'94, the later one looks similar to the one I have been sent.

yeah it is, the local motor factors got me that one as well:rolleyes: , it was a young know it all, who wun't listen.

give ebay clutches a wide birth and just buy an LUK or Exedy s13 clutch from a motor factor, lifes too short to waste on saving a few quid for the sake of 2 days extra work

Ordered an ADL blueprint 200SX clutch today for the silvia, does anyone know if these are ok ??