HELP needed in essex
 

Im doing a 18DET swap into my 12, engines in on the mounts and gearbox.... but i am completely hopeless with wiring the loom in. I've looked through the many guides and it jut gives me a headache.

Would anyone in essex like to come lend a hand doing the loom for fuel and beer money? pleeeaassseeeeeee :confused:

if you brought it down on a trailor to my garage i could do it but i dont fancy the drive up essex way. Last time i drove to essex for a 'simple job' it turned out about 5 different people had been touching the car. i had to spend days fixing there mess ups ( ie dizzy taken out and put back in out of time) etc before i could get onto the real issue :p

Sounds good to me. PM me your address and I'll get things sorted my end...

Thanks a million

Where are you located in Essex?

Also asking? I have my loom sitting ready to go in mine when I get round to it:cool:

The loom isn't hard providing its been removed from the car nicely

Im in thurrock... first exit after the tunnel and literally 2 mins round the corner. Whys that?

i have no idea where to start, but im in thurrock, i can pass mental helping thoughts.

Where in thurrock are you, so when your back on the road i can avoid the shame, lol

I'm in Hornchurch so aint too far.

What have you both got in terms of the loom? Got the section with the 3 green relays?

The relays is the part i think im missing? the loom was pretty much unplugged from everything not on the DET and then the engine pulled out with the loom still attached... then i picked it up... I dont see any green relays so im guessing i left them behind? :confused:

Im only in Aveley, Didnt relise there were so many 12's near me lol