|
#1
|
||||
|
||||
ABS on an S12
Is there any possible way I could put ABS on my S12?
And if so..... how?
__________________
|
#2
|
||||
|
||||
The S13's came with ABS so might be worth looking for one being broken on SXOC.
I guess you'd need... Wheel Speed sensors ABS ECU (If it's even separate) ABS Pump Might need the Servo and Master Cylinder A few lengths of Brake line and tools to make the ends up God knows how you'd go about it but anythings possible if you've got the time and money
__________________
|
#3
|
||||
|
||||
You would need the S13 front hubs and the S13 diff which has a sensor in it to get this to work. Or use an S14 system which I think has sensors on each rear driveshaft as opposed to the pinion shaft on the S13.
Again, why bother?
__________________
|
#4
|
||||
|
||||
Hi Rich,
This is one of the mods I`m doing to my s12. But I did have a complete 200sx donor car to start with. The ABS module is located behind the 200`s rear quarter panel. As I`m transferring the complete wiring loom over into the s12, it shouldn`t be too difficult for me (I`m using a modified version of the 200 dash also). But to be honest, I think it would be too much hassle just to install the parts separately . Regards, Ian.
__________________
|
#5
|
||||
|
||||
Maybe install an airbag too?
__________________
|
#6
|
||||
|
||||
and traction control, furry dice and cup holders...LOL...
I guess it`s down to personal choice though. I will be driving the car in anger a lot and considering the amount of rain we get up North, it seems a sensible decision to me. Plus I don`t know of any other s12 with ABS, so that`s a good reason in my eyes...LOL... . Regards, Ian.
__________________
|
Thread Tools | |
Display Modes | |
|
|