|
|
|
|
#1
10-09-2012, 11:05
|
|||
|
|||
Ball joint that fits?
Anyone recommend me a front bottom arm ball joint?
Just bought a Firstline one (FBJ5140), diameter is too small to press in!
__________________
1989 Mk2 Red Auto 1988 Mk2 Blue Manual 1988 Mk2 Red Auto (Ex-Silviagod) 1988 Mk2 Blue Manual (Donor) 
|
|
#2
10-09-2012, 15:43
|
|||
|
|||
|
Should fit! Have you cleaned out the whole of rust and crud etc
__________________
     
|
|
#3
10-09-2012, 15:49
|
|||
|
|||
|
Its not that it's too tight, it's that it's too loose meaning it would prolly fail MOT. Have just ordered a Dehphi one to see if it's any better.
__________________
1989 Mk2 Red Auto 1988 Mk2 Blue Manual 1988 Mk2 Red Auto (Ex-Silviagod) 1988 Mk2 Blue Manual (Donor)
|
|
#4
11-09-2012, 07:40
|
|||
|
|||
|
H'mm sounds like it been off before! I think you now may have two options, get another arm or stick some tack welds on it
__________________
|
|
#5
11-09-2012, 10:23
|
|||
|
|||
|
Fear you might be right, it had a nyloc nut on it for a start....but it was proper shagged, like 25 years of use shagged so who knows. Might have to consult my mammoth Silviagod service history :P
__________________
1989 Mk2 Red Auto 1988 Mk2 Blue Manual 1988 Mk2 Red Auto (Ex-Silviagod) 1988 Mk2 Blue Manual (Donor)
|
|
#6
13-09-2012, 11:38
|
|||
|
|||
|
Ok, Delphi joint just arrived (TC319) and it (press) fits perfectly. Although it has a grease nipple, old skool!
__________________
1989 Mk2 Red Auto 1988 Mk2 Blue Manual 1988 Mk2 Red Auto (Ex-Silviagod) 1988 Mk2 Blue Manual (Donor)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
