S12OC UK Forum  
S12 World Affiliate Program
S12 United Kingdom / Club-S12 International / / S12 France / S12 Eastern Europe / S12 Sweden

Go Back   S12OC UK Forum > Main Categories > S12 Discussion
User Name
Password
FAQ Members List Calendar Today's Posts

Reply
 
Thread Tools Display Modes
  #1  
Old 26-07-2013, 20:06
thenomisf thenomisf is offline
Registered user
 
Join Date: Oct 2012
Posts: 49
thenomisf is an unknown quantity at this point
Default Low Power under 2krpm, then Surge

Hi All,

I recently converted my S12 from auto to manual, but ever since it has had a weird "feature".

Under 2000/2500 rpm the engine feels good, but very dead on power (as you are pulling away), as soon as it goes over there is a very noticeable and sharp (almost feels like you have been rear ended) increase in power. It feels a lot like suddenly adding 5-10 degrees of timing.

This happens regardless of boost level or throttle position (and no its not just the turbo coming on, its a very sharp sudden change).

I have checked all my sensors and wiring, removed the auto trans electronics, I have no boost leaks. I can only assume there is a difference in timing map for the auto for smooth pull away (?) but I am told the maps are identical.

I am trying to get a timing light to check, but the service manual says auto/manual CA18ET should be timed the same ?

I am aware the knock sensor becomes active at 2200 RPM, but I would have though that would make it feel slower if it was retarding timing , but who knows!

Any ideas would be appreciated!
__________________
Reply With Quote
  #2  
Old 31-07-2013, 15:06
thenomisf thenomisf is offline
Registered user
 
Join Date: Oct 2012
Posts: 49
thenomisf is an unknown quantity at this point
Default

Think I figured this one out.

The adjustment pot/variable resistor on my MAF was dead and not giving a signal to the ECU (0 volts). This was making the idle mixture super rich.

The idle mixture according to some on the US forum is referenced up to 2000 rpm, found some gear in the service manual to support this.

I fitted a spare MAF I had, and adjusted the pot and it seems to have reduced the severity of the issue, if not completely cured it.

I have a timing light on the way to me so I can check that too!
__________________
Reply With Quote
  #3  
Old 31-07-2013, 16:00
northerner northerner is offline
PAID MEMBER
 
Join Date: Nov 2005
Location: Newcastle NE
Posts: 1,809
northerner is on a distinguished road
Default

Did you disconnect the Auto ecu box thingy inside the NSR inner arch?
__________________
Reply With Quote
  #4  
Old 31-07-2013, 17:53
thenomisf thenomisf is offline
Registered user
 
Join Date: Oct 2012
Posts: 49
thenomisf is an unknown quantity at this point
Default

I did yeah , as far as I could tell it only has a single feed wire back to the ECU which the ECU takes to ground when it wants to block lockup (cold start etc).
__________________
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 03:45.

Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.