I also followed the ECU pin diagram to find out for sure what each wire does on the brown and gray plugs. This is what I found
8 Pin grey plug :
Red/Silver band ECU 12v perm live PIN 58
Blue/Green silver band A/C relay *NOT USED*
Black/White silver band ECU eccs 12v switched PIN 109
Blue/Red Plug loom 12v switched (no pin)
Black/Red Ign power 12v switched PIN 45
White (shielded) Knock sensor (I will wire this in further towards the bulkhead)
8 Pin brown plug
Green/Yellow silver band A/C relay *NOT USED*
Black/Red silver band Eccs power 12v switched PIN 16
Green/Orange silver band Inhibitor relay *NOT USED*
Black/Purple Fuel pump relay PIN 18
(NOT SURE WHICH PIN ON THE FUEL PUMP RELAY)
Black/Yellow ***** Dont know what this is ???!!****
Brown/silver band O2 heater (my ECU plug does not have an 02 wire)
Now I think I have all these correct (if not then say!) but I need to know if my dodgy relay wiring is OK ? Can I run one Permanent Live/One switched 12v/One ground jumped through all the relays ???
