|
|
|
|
#1
01-05-2006, 17:29
|
||||
|
||||
cam timing
here's a question for you, i'am fitting a new timing belt but i'am a bit
 it shows in the book on em-6 that the pointing arrow points to the first notch on the bottom pulley, but i'am sure that last time i set it on number 2 notch, i'am sure 30psi said to use numbur 2 notch as well if so why is this.
__________________
 fj20/et a replacement for displacement 
Last edited by s13eater; 02-05-2006 at 14:09. 
|
|
#2
01-05-2006, 17:39
|
||||
|
||||
|
the drawing is not 100% accurate shaun if you count backwards from 20deg. mark then the mark shown is tdc, no2 as you count it
Last edited by Dr Silvia; 01-05-2006 at 17:43.
|
|
#4
01-05-2006, 21:52
|
||||
|
||||
|
For anyone thats read this and thought WTF is shaun on about he refers to the timing marks on the bottom pulley.
There are 6 marks From left to right: 5 ATDC, TDC, 5 BTDC, 10 BTDC, 15 BTDC, 20 BTDC ATDC - After top dead centre TDC - Top dead centre BTDC - Before top dead centre
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
