headgasket

PukkaSilvia · #1 03-12-2006, 18:09

i wouldnt either. years and years ago Dr silvia used engine flush on one of his et engines and on next start up oil pissed out the side of his gasket

. . Adzs12 headgasket went rotten most recently aound his water ways. there old engines and most of them still on the original head gaskets

The head gaskets go rotten

.

30psi · #2 03-12-2006, 23:43

It could well be the oil feed, as it goes that way on the mk1 engine. Its held by the inlet manifold bolts, so could well be the issue.

datdrift · #3 04-12-2006, 08:50

ive had a look this morning in the light, but i still can't really see anything

its really tricky to look under the inlet manifold, ive tried using a little mirror, etc but its all pretty oily under there so its hard to say where its coming from.....how would i go about removing the oil feed with the engine in the car? i'm gussing i'll have to take the oil filter off....

heres a little pic of the starter with a little oil resivoir on top of it, the oil's pissed everywhere, all down the chassis/inner wing, etc
also the snapped head bolt is on the other side of the head so i would have expected that side to go first?

30psi · #4 04-12-2006, 08:54

That side of the head is the pressurized side. You might struggle to remove the oil line, without removing the inlet manifold.

datdrift · #5 04-12-2006, 10:54

Quote:

That side of the head is the pressurized side

meaning it would piss oil everywhere like it has if the gasket went? ive pulled out my spare lump and taken the turbo off it, just gonna have to start pulling this lump out now......all fun and games

30psi · #6 04-12-2006, 11:00

Well yesterday, I actually helped someone do the headgasket on their S12.

This one suffered water getting into the combustion chambers, and the reason was due to the HG rotting from lack of anti-freeze.

However, there's one pressurized area, and its right beside a head bolt. Its the inlet side, 2nd one in from the rear.

In my opinion I'd be surprised that its rotten the gasket there though

datdrift · #7 04-12-2006, 18:40

ok so i pulled the engine out had a little look at the side of it and it all looked sweet, apart from a bit of oil here and there......couldent see any signs of oil coming out of the headgasket so started to take the oil feed off, even tho it looked fine as well, and when i went to undo one of the bolts holding it to the engine one side of the feed just came away and sheared off, so it was obviously leaking from there

so now i don't know what to do, put this engine back in or my spare

i think i did about a mile with barely any oil pressure getting to the services with it, the temp dident rise but it dident have much oil left in it, i was only doing about 50mph tho......or put my spare in which came out a crashed car and hasent been run for over a year

i think i'll have a beer and sleep on it and decide tomorow

adzs12 · #8 05-12-2006, 00:50

Quote:

Originally Posted by 30psi

This one suffered water getting into the combustion chambers, and the reason was due to the HG rotting from lack of anti-freeze.

Thats what happened to mine, it had rotted around the water ways and created a small split into the ring of cylinder 3