"det" inlet on to "et".....help!

30psi · #1 05-03-2007, 10:04

Silvia Engineering did it.

I imagine you'd have to be pretty damn good at tig welding to do it.

s13eater · #2 05-03-2007, 10:23

tbh, i would fabricate my own plenum, you may as well design a better plenum, it would be not much more to do your own and easier by the look of that, bad welding on there mart, ally weld needs a lot of practice.

30psi · #3 05-03-2007, 10:27

I think they just blitzed it with weld to penetrate through to the other side.

Its cast ali as well which will make it harder to weld.

You could use a CA20 inlet, and swap the ends over.