Breaks

[sideways danny]

Originally Posted by Speedycougar

What fitment are S12 discs (PCD?). Perhaps Dan at DB Power can do some Brembo M3 Disks for the S12 cheaper, as I remember he ran a group buy for the S14 crowd with redrilled disks (It is what I had on my S14a).

Matthew

very unlikely to work, s12 discs sit inboard of the hub. I think z31 discs are 296mm (have to check though) if they are r33 gts calipers would be ideal to go with them. now stop giving me ideas

[alundra]

What pads do you have?

[Speedycougar]

Originally Posted by sideways danny

very unlikely to work, s12 discs sit inboard of the hub. I think z31 discs are 296mm (have to check though) if they are r33 gts calipers would be ideal to go with them. now stop giving me ideas

Danny... GET CHECKING!!! (oh and p.s. what size wheel minimum would you need to fit 296mm into? [obviously we are not sure about caliper size as of yet]).

Don't know about the pads. Anyone else know?

Matthew

[sideways danny]

http://www.nissansilvia.co.uk/vbb/showthread.php?t=1542

knew i'd seen 296mm discs somewhere

[30psi]

You can just have the discs drilled to attach to the hub from the rear. Someone with a datsun with s12 legs tried it with Z32 discs and the caliper was correctly spaced as well.

[doski]

i have nearly finished a full s14 brake set up on s12 hubs, need long wheel studs , s14 disk redrilled to 4 stud and the calliper will need spacing, i am just getting some spacers made up think they need to be about 11.5mm

[s13eater]

Originally Posted by doski

i have nearly finished a full s14 brake set up on s12 hubs, need long wheel studs , s14 disk redrilled to 4 stud and the calliper will need spacing, i am just getting some spacers made up think they need to be about 11.5mm

let us know how you go on, i have the s14 calipers, but with grooved s12 discs, i'd be interested in getting some bigger fronts on there and what about the rears, is there anything we can do to improve those ?

[30psi]

Be worth trying to get the disc redrilled so it can be bolted to the rear of the hub before trying to make spacers

[sideways danny]

Originally Posted by 30psi

You can just have the discs drilled to attach to the hub from the rear. Someone with a datsun with s12 legs tried it with Z32 discs and the caliper was correctly spaced as well.

should work the same with the M3 kit then. nice

[30psi]

Yeah but it will be to the PCD of the inner hub bolts which arent the same as the PCD of the wheels me thinks. But if the offset this way isn't an issue then for this method its a damn handy upgrade