|
|
|
|
#1
15-01-2008, 14:35
|
|||
|
|||
if you can't get a lead you can just bridge the 2 wires with a resistor. The sensor itself doesn't really do a lot and you shouldn't rely on it fo knock protection, but if you dont fool the ECU into thinking it's there the timing will be retarded 5 degrees (iirc) over 2k rpm so you'll lose power
|
|
#2
15-01-2008, 15:05
|
|||
|
|||
|
Danny,
To be honest mate, if I can't find the lead anywhere it'll be a 5 minute job to lop off the round pin connector and wire up with some some spade connectors - thankfully the car is over a pit, so I can access the sensor easily from below. But I accept that it would run with just a resisitor too. Cheers, Jamie
|
 |
|
|
Hybrid Mode
