South Yorkshire Springs CoilSpring Info

[s13eater]

what i did when i had the std front struts with avo springs is, weld 2 u shaped pieces to the top cup, then thread the top of the spring through, then on the bottom, drill 3 evenly spaced holes into the bottom spring cup, then make 3 z shaped lugs to hold the spring to the seat.

[umpkin]

ahh yeah, i remember you saying about this before, might try that.

[umpkin]

shaun, i phoned valley springs today, they told me they havnt got any pattern for my car, so i would need to supply them with an old spring before they can quote me on them.

did you have to give them a pattern when you got yours done???

or if your passing could you pop in and give them any info they need and ill phone the next day or somin. i cant send them one of my springs, coz then my front spoiler would drag the floor when i drive to to work, lol

[s13eater]

hi mate, i can call in on thursday as i'am near them when i go shopping, i've been past today, i have the front and rear hieghts and poundages in the manual, but could you count me the coils on front and rear springs and if you have any vernier calipers, then perhaps measure me the thickness of the wire on both, cheers.

[umpkin]

the manual says the wire size is 13.2mm how will they get the ride height right?? i want -25mm rates 350lbs. if the rate is to high, what cons would there be???? i dont mind the ride being really bumpy, its not a family car, i want it cornering like its on rails. i dont want sloppy

[s13eater]

the manual gives you the std spring length as well, he puts it all into a pc program and it gives you the lenght ,rate, wire thickness and how many coils you need.

[umpkin]

do you recon he can do it with a lazy top coil, so i dont have to mess about making brackets to tie them in the strut. you still need me to count the coils???