![]() |
|
#1
|
||||
|
||||
![]()
Easy on the rear. Easy on the front too, its just messy due to the wheel bearing which you should repack wth grease and also not over tighten
__________________
![]() |
#2
|
|||
|
|||
![]()
Thanks mate!
How check bearings with the wheel on? |
#3
|
||||
|
||||
![]()
The service manual explains how to check the resistance of the bearing, but you did it with the wheel off
__________________
![]() |
#4
|
|||
|
|||
![]()
about the nut for front disc I have a 32mm tool, is it good? Seems a littre free.
|
#5
|
||||
|
||||
![]()
Its done up with very little torque. Very low. Something like 10nm, but you need to check the service manual
__________________
![]() |
#6
|
|||
|
|||
![]()
if you can get one..gumble...grumble
|
#7
|
||||
|
||||
![]()
25nm i think mart, i'll check, still not a lot though
![]()
__________________
![]() |
![]() |
|
|