s12 walbro fitting guide

[PukkaSilvia]

The ballcock control arm can be bent to adjust the float level. I havn't needed to do this as my pumps pickup sat exactly at the same height as the standard s12 pump. I will road test it and if needed (i doubt it) bend the control arm.

The walbro was not as thick in diameter as the std pump as i managed to trim one standard pump rubber spacer and insert it inside the other before sliding it over the walbro.I did not have to bend my cradle about to get it in

[turbozx]

i want to fit one of these to my bluebird turbo, are all walbro 255 pumps the same, dont think they will do one for a Bluebird turbo so should i buy one for a 200sx s13?

were did you get yours from and was it car specific.

[30psi]

Just use the S13 one. They're not designed for any car particularly. They sometimes come with the hose can cable ties to help fit it to a certain car.

Just make sure it sits as low as the standard pump as you don't want to run out of petrol early.

[turbozx]

cheers thought so but needed a second opinion, just fitted a t25 and the adjustable actuator you sold me so before i turn it up to a bar, i want to make sure the fueling is good. cheers

[30psi]

Cool, that acuator is nice and tight isn't it?

[turbozx]

ye feels good running about 10 psi at the mo, and theres loads of adjustment left. cheers