Intercooler Piping

[marcusp88]

So you dont think 51mm will be too narrow for 200bhp? Its the same diameter as the original pipe that runs from the turbo to the t.b.

[paulsilv]

Just changed from T2 to T25, had 63mm on T2 and gone back to 51mm on T25 just because it was easier and I had the pipes laying around FREE.

Not sure what difference it would make maybe some scientific member could give us the low-down on airflow calculations.

wacomuk
like how you have mounted your radiator, did you tack tabs on the end of your radiator or just bolt it straight on?

[marcusp88]

How does the car feel with the 51mm on the T25 and what boost are you running?

If its good enough for a T25 a T2 shouldt be a problem.

[wacomuk]

Originally Posted by paulsilv

Just changed from T2 to T25, had 63mm on T2 and gone back to 51mm on T25 just because it was easier and I had the pipes laying around FREE.

Not sure what difference it would make maybe some scientific member could give us the low-down on airflow calculations.

wacomuk
like how you have mounted your radiator, did you tack tabs on the end of your radiator or just bolt it straight on?

i fixed an aluminum angle on to the subframe (about 100mm closer to the engine) drilled 2 holes in the angle for the rad to drop in to (20mm ish holes) i used 100mm threaded bar and 100mm alloy tube to space the top

[wacomuk]

Originally Posted by marcusp88

So you dont think 51mm will be too narrow for 200bhp? Its the same diameter as the original pipe that runs from the turbo to the t.b.

Should be fine

[paulsilv]

Car feels very strong on 51mm with T25, I'm running 12PSI as I haven't changed it as yet from the T2 I was running.

Well chuffed with the feel of uprating to a T25