|
|
|
 /
 /
 /
 /
 /
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
22-08-2013, 13:11
|
|||
|
|||
Yea mate, made use of all the fuses, wherever the original loom was fused, there are too.
|
|
#2
25-08-2013, 23:20
|
|||
|
|||
|
Ok so i can't seem to get the signal from the ECU to activate the fuel pump, the only way i can get it going is to manually ground it at the back so the pump turns on when ignition turns on but this isnt really good for safety reasons!?
I tried to trace the fuel pump grounding cable to the old engine loom connector ends but failed, can anyone fill me in? Also realised that when i got the engine i must have overlooked the dropping resistor so I dont have one. However... I've ordered one and it should be here tuesday 
|
|
#3
26-08-2013, 08:49
|
|||
|
|||
|
SHi I mine I had trouble finding the wire to so I have run a 12 v supply site switched snd earth to the body and I have the ecu swicthed on the same way your doing a great job cant wait to see it done
|
|
|
|
Hybrid Mode
