|
|
|
|
#1
30-05-2006, 01:42
|
||||
|
||||
The front wipers are on a small toothed spline for which you have to remove the wipers and simply move them to what posistion you want.
As for the back it could be a number of things including the wiring to the motor or the motor itself, swapping the motor is not a hard job atall 
__________________
 Currently 226.4bhp@13psi with a remap to 18psi coming very soon 
|
|
#2
30-05-2006, 03:15
|
||||
|
||||
|
well the front wipers are hard because there are the rods attached underneath and i dont know where to disconnect it. and the back one i ne ver tried or seen what it looks like under the cover but doesnt it have the rods there too?
__________________
1987 s12 => Under Construction 1986 s12 55k mint (ca18et)
|
|
#3
30-05-2006, 07:20
|
|||
|
|||
|
you dont have to mess with the rods underneath,at the base of the wiper arm itself there is a single nut which probably has a press on cover over it,take the nut off then pull the wiper arm off the spline and readjust where you like,same on the back
|
|
#5
30-05-2006, 08:48
|
|||
|
|||
|
the wiper arms may be stuck on there really tight. Don't be afraid to use lots of force and wiggling to get them off.
|
|
#6
30-05-2006, 09:13
|
||||
|
||||
|
its a 14mm spanner you will need, just put some pressure on the bottom of the wiper arm with your thumb, so when its undone it keeps the pressure even on the spline, then lift with the other hand, this will stop you trying to lever it off and break things
__________________
 fj20/et a replacement for displacement 
|
|
#7
30-05-2006, 23:03
|
||||
|
||||
|
thanks for the help guys, i fixed the front and back wipers today. next up is switching the suspension and shocks rotors use s14 calipers and start fitting headlights
__________________
1987 s12 => Under Construction 1986 s12 55k mint (ca18et)
|
 |
|
|
Hybrid Mode
