Door pins

northerner · #1 10-07-2006, 20:18

Basically you have a pin that is held in by a c clip. You take this off after supporting the door. Then you tap out the upper and lower Brass rings from the hinge and tap in the new ones. If your door pin is worn then this will have to be changed. Take about an hour each side If you take your time

blueneon · #2 10-07-2006, 20:47

so you tap the pin out, and the brass bushes slip over the pin?

northerner · #3 10-07-2006, 20:49

the brass bushes are in the hinge which need to be tapped out after the pin is removed. From what I remember they are in the door side of the hinge as its been a while.

JamesS12 · #4 12-07-2006, 20:05

Obviously a common silvia thing...put me down for 2 dodgy doors

30psi · #5 13-07-2006, 08:43

I've got a new door pin set for when I change the door on the s12

umpkin · #6 13-07-2006, 20:22

dont suppose you have 2 doors and 2 wings, mine are a tad rusty

else i shall have to fire up the welder to repair the wings, and grind out the rust and p40 the the doors

s13eater · #7 13-07-2006, 20:29

i have 1 spare door, but your a long way from me.