|
|
|
|
#1
14-08-2006, 09:41
|
||||
|
||||
Looking very clean
 With some mint rear lights she will look even better.. A fibreglass copy rear spoiler would be a good idea i think
__________________
 Quote:
|
|
#2
16-08-2006, 15:38
|
|||
|
|||
|
Starting problems!
Well I went to start the car this morning and it didn't want to go! So I whipped out the Ecu and it gave the Water temp sensor. Upon checking it, I found that the connector was half missing and the contacts were rotten. Also as I pulled it off, I found one of the wires had been soldered before and snapped. So I fixed it using a decent Injector connector I had lying around and soldered the joints good and proper, job done!. I also took off the Coil and cleaned up all the wires and metal joints and added another Negative wire to the inner body. These are really prone to corrotion! No more starting problems.
__________________
     
|
|
#3
17-08-2006, 09:00
|
||||
|
||||
|
Biggus
do you mean the Man who used to have a white s12 and then had a green p11 primera gt, if it is Oh my god!!!
If it is ask him about the time Me and s13 eater and afew others stacked a picnic bench , about 100 beer bottles and half the site rubbish bags infront of his tent a billing one year,  . Hope itis , soorry if it not and did'nt mean to take over thread, i think i might have two rear lights if you want them , Let me know
__________________
212bhp at the wheels on standard internals. 
|
|
#4
17-08-2006, 09:16
|
|||
|
|||
|
Kenny yes its Richard. Hes sort of gone astray recently. Hes settles down with a lady and is well into racing model cars. Haven't spoke to him for ages!. I've managed to get some lights from Speedfreak, Thanks anyways
__________________
|
|
#5
17-08-2006, 11:21
|
|||
|
|||
|
Just had a look at the rear pads and OMG they were on the wafer Thin side. Good job I had a spare set lying around. To my amazement, I found that the rear calipers are Reconditioned units. Still got the stuff they put on them to stop the Rust !. Right result
__________________
|
|
#6
17-08-2006, 13:14
|
||||
|
||||
|
Quote:
 )
__________________
Only 450+ BHP from a 1.8? (Well, until I can run big boost again ) - Still, back on the road and looking for victims - Muhaahaahaaa!.... Yep - I fookin' love me beast ... 
|
|
#7
29-09-2006, 16:23
|
|||
|
|||
Smoking like a trooper !!!
Well I thought it was too goo to last. Yesterday morning on the way home from work my Auto started smoking like a trooper whilst sat at a roundabout. Well today I did a compression check and all was OK 150 in each pot. Next was the Tubby fine no leaks. I've only done 1k since I started this thread so I was stumped. I took off the tubby to find no.4 exhaust was full of oil! I called the God and we thought maybe rings or HG so Off came the head.
Well on close examination of the head you won't believe what I found. The valve stem oil seal on No.4 exhaust valve was just popping up and down and had not been fitted properly. Well I could not believe it, it was amazing how much smoke could be caused by One valve. Anyways after frantic calling round, I got the head skimmed and will refit it tomorrow. The moral of the story 'Dont *ucking trust anyone to do a good job !' 
__________________
|
|
#8
11-01-2007, 17:20
|
|||
|
|||
|
*********now For Sale**********
NOW for sale as I'm going to OZ. Available at the end of JAN. MOT NOV07 TAX JAN07 but can tax for you. 98/99k Bright red paintwork. Interior is 99% mint. Face off cassette/radio. Runs great burns no oil smooth as silk loads New parts as this list. Recent plugs/oil/filter service. Totally standard as in the pics Only fault is the bottom of the wings which need attention. £550 ovno! or goes on ebay
__________________
|
 |
|
|
Hybrid Mode
