|
|
#1
12-04-2006, 17:31
|
||||
|
||||
pcv
i dident want the dirty oily air from the pcv hose going back thru my turbo and engine, so i blanked off the hole on the inlet pipe with a modified wheel nut, and fitted a oil catch can, an old oil container
 i cut the lid bigger than the size of the tube so the air can flow through and cable tied some stuff is this alright/effective  i need to tidy/clearout my garage  
|
|
#2
12-04-2006, 18:00
|
|||
|
|||
|
that will work ok , but it's not the PCV, that's the one that comes out of the crank case and goes into the inlet manifold. Ideally you would block the PCV valve and run a hose from the crank case breather to the same catch tank
|
|
#4
14-04-2006, 21:36
|
||||
|
||||
|
just put a breather filter on the end where the crankcase lid is... spot on that. did that myself, you can get breather filter for next to nowt..
__________________
if it's got tit's or wheels, it's gunna give you grief.! 
|
 |
|
|
Linear Mode
